User Tools

Site Tools


beamracer_installation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
beamracer_installation [2022/07/18 11:21] – [Obtaining access] silverdrbeamracer_installation [2022/07/18 11:24] (current) – [Installing riser socket] silverdr
Line 56: Line 56:
 All "wide" Commodore 64 boards require that you place the rising and protective socket on the pins sticking out from the bottom of the BeamRacer board. This additional socket not only keeps the BeamRacer unit safely above the computer's mainboard but is also especially chosen to have //flat// pins, rather than round ones. Thanks to this no additional wear is imposed onto your original VIC-II socket when the expansion is installed. All "wide" Commodore 64 boards require that you place the rising and protective socket on the pins sticking out from the bottom of the BeamRacer board. This additional socket not only keeps the BeamRacer unit safely above the computer's mainboard but is also especially chosen to have //flat// pins, rather than round ones. Thanks to this no additional wear is imposed onto your original VIC-II socket when the expansion is installed.
  
-<fc #cd5c5c>NOTE: If your compouter's mainboard is one of the [[narrow_boards|"narrow" ones]] AND your computer case is of the newer, "flat" type – the Commodore 64C units fall into this category – you may elect not to install the riser socket and follow the [[c64c_installation|C64C specific installation procedure]] instead+<fc #cd5c5c>NOTE: If your computer's mainboard is one of the [[narrow_boards|"narrow" ones]] AND your computer case is of the newer, "flat" type – the Commodore 64C units fall into this category – you may elect not to install the riser socket and follow the [[c64c_installation|C64C specific installation procedure]] instead
 </fc> </fc>
   - Check and align orientation notches on both the BeamRacer top socket and the riser socket   - Check and align orientation notches on both the BeamRacer top socket and the riser socket
beamracer_installation.1658168484.txt.gz · Last modified: 2022/07/18 11:21 by silverdr